To achieve optimum work results with the FEIN cordless screwdriver ASCM 18-4 QM(P) using the HOLESAW ADAPTER and TCT HOLESAWS, it is important to observe general guidelines depending on the application. The following maximum outputs can be achieved:
- Max. Drill Ø in sheet metal, material thickness 4 mm with TCT hole saw QIP: Ø 80 mm
- Max. Drill Ø in steel, stainless steel pipe, material thickness 4 mm with TCT hole saw for pipes QIP: Ø 68 mm
HAND-GUIDED HOLE SAWING WITH HM HOLE SAWS / HM HOLE SAW FOR PIPES QUICKIN PLUS
1
First step: Centre drilling
3rd gear, 2,000 rpm, accessory: CENTRING DRILL
- Centre drilling in one operation.
- Sufficient cooling / lubrication.
- Gear change depending on diameter.
- After material breakthrough of the carbide hole saw, return from the finished drill hole in turning mode.
2
Second step: Hole sawing
Accessories: Carbide hole saw Ø 14 - 29 mm, 2nd gear, 850 rpm
- Maximum recommended material thickness 4 mm.
- If necessary, 6 mm is also possible.
Accessories: HM hole saw Ø 30 - 59 mm, 1st gear, 430 rpm
- Throttle switch pressed to maximum.
- Maximum recommended material thickness 4 mm.
- If required, 6 mm is also possible.
Accessories: HM hole saw Ø 60 - 80 mm, 1st gear, 430 rpm
- Throttle switch pressed halfway for optimum drilling progress.
- Maximum recommended material thickness 4 mm.
- If required, 6 mm is also possible.
HAND-GUIDED HOLE SAWING IN STAINLESS STEEL SHEET WITH HM HOLE SAWS / HM HOLE SAW FOR PIPES QUICKIN PLUS
3
First step: Centre drilling
3rd gear, 2,000 rpm, accessory: CENTRING DRILL
- Centre drilling in one operation.
- Sufficient cooling / lubrication.
- Gear change depending on diameter.
- After material breakthrough of the carbide hole saw, return from the finished drill hole in turning mode.
4
Second step: Hole sawing
Accessories: HM hole saw Ø 14 - 44 mm, 1st gear, 430 rpm
- Throttle switch pressed to maximum.
- Maximum recommended material thickness 4 mm.
- If necessary, 6 mm is also possible.
Accessories: HM hole saw Ø 45 - 80 mm, 1st gear, 430 rpm
- Throttle switch pressed halfway for optimum drilling progress.
- Maximum recommended material thickness 4 mm.
- If required, 6 mm is also possible.
